AR buffers and what they mean to you

Another interesting topic for the AR-phile is that of buffer weight. The buffer is a counterweight that works with the buffer spring to absorb the recoiling bolt assembly and then push it back into battery. It can be seen in this video in the area of the guns stock:

The buffer comes in different weight classifications and lengths. The buffer for a carbine is shorter than that of a full sized rifle. Buffers typically come in CARBINE/H/H2 and RIFLE sizes from lightest to heaviest.

Why should I care about buffer weights? Well… hotter loads and shorter barrels with shorter gas tubes result in greater operating pressures. This means that the bolt assembly is cycled faster. Sometimes it can cycle so fast that the bolt out-speeds the spring in the magazine that is trying to push the next bullet up into the chamber. This can be a big problem in automatic fire. The result is mis-feeds (or no feed at all) and more wear and tear on the guns parts.

A heaver buffer slows the system down and increases “lock time”, which is the amount of time between when the round is fired and when the bolt begins to move rearward. This aids in extraction of the spent case and the heavier counterweight can reduce felt recoil. The following vid is for comparison:

One has to be careful that he/she doesn’t go too heavy though, because then the bolt carrier may not move back far enough to strip the next round from the magazine. It may also not lock back on empty or cause other timing issues.


One thought on “AR buffers and what they mean to you”

  1. Another alternative is an adjustable gas block. You can tune it to restrict as much gas as possible but still offer reliable operation. This reduces the wear issues as well as recoil.

    If your front sight is the A2 A-frame sight with an integral gas block then it is likely that you will have to get a new sight when you replace the gas block. This was not a problem for my application as I wanted a flip up BUIS so that it is out of the sight picture while using a holosight. Syrac Ordinace makes a clamp on low profile adjustable gas block that will fit inside most free floating rails which means you can take advantage of some of the accuracy improvements of a free floating rail and a clamp not screws that press against the barrel as well.

    Replacing the buffer is easier for the novice as the gas block has to be aligned when placed on. You also must go to the range and tune the block for the ammo you intend on shooting however that is fairly easy to do and the detent on the Syrac Ordinance one holds your setting in place.

Leave a Reply

Fill in your details below or click an icon to log in: Logo

You are commenting using your account. Log Out /  Change )

Google+ photo

You are commenting using your Google+ account. Log Out /  Change )

Twitter picture

You are commenting using your Twitter account. Log Out /  Change )

Facebook photo

You are commenting using your Facebook account. Log Out /  Change )


Connecting to %s